Question: Can you use an inground pool pump on an above ground pool?

Can an Above-Ground Pool Pump Be Used on an Inground Pool? Of course, you can. Your inground pool would have to be situated above your above-ground pool pump. It also depends on the size of the pool.

Can I use inground pump on above ground pool?

Inground equipment can sometimes be used on aboveground pools, but many times it is too large or too powerful, and could damage other equipment, or the pool itself.

What is the best pump for above ground pool?

The 10 Best Above Ground Pool PumpsOur #1 Pick: Intex Krystal Clear Sand Filter Pump. Intex Krystal Clear Cartridge Pump. Hayward Power-Flo Above-Ground Pool Pump. Hayward Super Pump. Harris Above-Ground Pool Pump. Hayward Power-Flo Matrix Above-Ground Pool Pump. Hayward Perflex DE Pool Filter and Pump System.More items •1 Apr 2021

Do you need a pool pump for above ground pool?

Above-Ground Pool Pumps To keep the water clean and circulated, you will need a pump and filter for your pool. The size and capacity of these units vary and will need to match the volume of your pool. When in doubt, consider going with a slightly bigger pump than you think you need.

What does a pump do for an above ground pool?

One of the most important parts of your above ground pool is the pump. The pool pump circulates the water through the filter system, which cleans any debris from the swimming pool. Without the water moving around regularly, algae may start to form in your pool water.

Are pool pumps gravity fed?

Inground pool pumps have a natural enemy named Gravity as well as air pressure working against them at all times. The diffuser is a shroud that sits over the pumps impeller. The impeller is a vented disk screwed to the motors shaft tip to transform the spinning of the motor into water pulling force.

Can a pool pump be lower than the pool?

In-ground pool pumps are commonly self-priming, which means that they can create enough suction to lift water vertically, as much as ten (10) feet in most cases. However, when pumps are more than a few feet above the pool water level, it can become easy to develop pool priming issues.

Can a pump be too big for a pool?

There is a very persistent myth in the pool world that the higher the horsepower, the better. As a result, it is probably safe to say that the majority of pools have oversized pumps. Too large of a pump can cause poor filter performance and even damage it, if the filter is not also oversized accordingly.

How much does an above-ground pool pump cost?

If you have a typical above-ground or in-ground pool, this is most likely the type of pump youll get. The average pool pump cost for this style ranges between $300 and $800.

What is the average cost to install an above ground pool?

When you add up all the costs, a permanent above ground pool might cost between $10,000 and $20,000. This is still far less than the cost of an inground pool, which will set you back $50,000 to $100,000 and youll get as much enjoyment out of a good quality above ground pool.

What size pump do I need for a 15000 gallon pool?

about 20 GPM A 15,000-gallon pool needs about 20 GPM output if we want to run it 24 hours per day. Most people run their pool on an 8-hour on/16-hour off (stagnant) cycle.

What is the difference between a pool pump and a pool filter?

Pool filters and pumps keep the water clean. The filter does the heavy cleaning while the pump moves the water to the filter. Together, they create the proper environment for proper pool water filtration.

Can you use a pool vacuum on an above ground pool?

Fortunately, both manual and automatic pool vacuums can work in an above ground pool. Lower the assembled vacuum into the water until the head is touching the bottom. Keeping the vacuum pole locked in place, hold it down with one hand and make sure the head stays in contact with the floor of the pool.

Can dog hair ruin a pool pump?

Although their hair and dander is harder on a filter system, it is not known to cause serious damage if properly maintained. Another way to maintain your filter system is to use a skimmer sock to catch dog hair so you can remove it from the pool before it goes through the system.

Can I replace my 1hp pool pump with a 1.5 HP?

So to answer the question, yes, you can replace your 1hp pool pump with a 1.5hp pool pump, but only if your situation calls for it. This will provide the flow that is needed to circulate your pool water properly and save you from high electricity bills at the same time.

How long do pool pumps usually last?

Pool Pumps Your pools pump is the wet end of the operation, it houses the pump basket. Pumps should last through the initially installed motor and perhaps as many as two or three replacement motors, usually 10-12 years. Modern pumps are made of hard plastic and will over time warp.

Can I leave my pool pump on overnight?

It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.

Write us

Find us at the office

Kyker- Kublin street no. 42, 51864 Pretoria, South Africa

Give us a ring

Carnell Mckean
+65 937 708 93
Mon - Fri, 10:00-20:00

Contact us