Since pumps for above grounds only come as 120V, they all have standard three-prong plug cords attached to them. So due to these pumps having standard cords on them, the easiest way to get power to your pool is to use an extension cord connected to some outlet from the house.

Do you need a special outlet for a pool pump?

A pool pump requires a great deal of power and that you cant provide with a normal extension cord. Youd need one with a #12-gauge wire or a #10-gauge wire. The pump should be plugged into a dedicated circuit, a circuit or line or outlets that only goes in two directions, the outlet, and the electric box.

How do you replace a pool pump plug?

0:544:25How To Add Power Cable To Pool Or Spa Pump - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe first thing youre going to do is take your quarter inch socket. And loosen up that screw at theMoreThe first thing youre going to do is take your quarter inch socket. And loosen up that screw at the back of the cap. Once you get that screw loosened up you just pull the cap. Off.

Can a pool pump be plugged into an extension cord?

Running your pump with an extension cord voids the warranty in most cases. Running the pool pump motor with an extension cord that is not adequately paired for the filters power will damage the motor. At times, pool owners, however, use extension cords in lieu of a costly job to bury a power line beneath the ground.

How do I remove the plug from my pool pump?

0:020:53How To Drain Your Hayward Northstar Pump - YouTubeYouTube

Can you replace a cord on a pool pump?

Re: changing pool pump cord If your pump is 110, and your outlet is 220, you cant do this. But, if your pump can also be wired for 220, (its in the manual) you would do much better to replace the cord with a twist-lock assuming the outlet turns out to be 220.

Where is the pool pump drain plug?

plug without an O-ring. Pool pumps usually have two pump drain plugs: one in the front, at the base of the hair and lint strainer or pump pot, and another plug further back toward the motor to drain the volute, or impeller housing.

How do I remove the plug from my pool skimmer?

How to Remove In-Ground Pool Skimmer PlugsRemove any debris or equipment from the area around the skimmer. Ensuring the area is clear prevents debris or other objects from falling into the pool lines.Unscrew the skimmer plugs from the skimmer hole. Pull the plug out of the skimmer hole.

Does a pool pump need to be twist-lock?

Usually a twist-lock plug is required (When pump is located between 5 and 10 feet of the pool). It really (obviously) should not be installed closer than 5 but if the receptacle is 10 or more away from the pool, the pump can be direct wired (or a regular blade type plug can be used if Im not mistaken.

What size wire should I use for my pool pump?

Lastly your pool pump motor must be bonded in accordance with local electrical code requirements. Use a solid copper conductor, size 8 AWG or larger. Run this wire from from a reinforcing rod to the pressure wire connector provided on the motor housing.