The electrical component that activates a valve to allow water to flow into the ice making area is called the solenoid. Coils that form the solenoid can become damaged over time, causing the icemaker to act erratically or produce no ice at all.
How do I test my ice maker solenoid?
0:572:46Refrigerator Not Making Ice? Inlet Valve Test, TroubleshootingYouTubeStart of suggested clipEnd of suggested clipWhen. Using a digital model again rotate the dial to the lowest setting for ohms of resistance orMoreWhen. Using a digital model again rotate the dial to the lowest setting for ohms of resistance or resistance with tone if your meter has this option be sure to unplug the refrigerator. Before. You
How do you replace a solenoid on an ice maker?
1:113:46Whirlpool Refrigerator Ice Dispenser Solenoid #W10309866 - YouTubeYouTubeStart of suggested clipEnd of suggested clipDisconnect the wire connector. And use a quarter inch socket or nut driver to remove the screwsMoreDisconnect the wire connector. And use a quarter inch socket or nut driver to remove the screws securing the grounding wire. Pull the retaining tab back and remove the old solenoid from the housing.
How do you test a water solenoid on a refrigerator?
0:392:23How To Test Your Fridges Water Valve - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe two metal probes together will zero out to test your Bell touch one probe to each terminalMoreThe two metal probes together will zero out to test your Bell touch one probe to each terminal depending on the part your valve canary between 200 and 500 ohms.
Why does my ice maker overflow with water?
If the water pressure is too low, the valve may not close fully once the power is shut off. As a result, the valve will leak water into the ice maker and cause the ice maker to overflow. If the water pressure is sufficient, but the ice maker is still overflowing, replace the water inlet valve.
What would cause an ice maker to stop working?
Cause: A common cause for a clog is frozen water in the line. Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).
How do I control the water flow on my ice maker?
Turn the small adjustment set screw on the upper, middle right hand side of your ice maker a half of a turn with a Phillips or flat head screwdriver, depending on the screw your ice maker has. Turning the screw clockwise will decrease the water level and turning it counterclockwise will increase the water level.