8. Vacuuming pool with filter valve in backwash position. When a pool is vacuumed with the sand filter valve in the filter position, the dirt and debris that passes through the pump ends up inside the filter on top of the bed of sand which is where you want it.

Should I vacuum on waste or filter?

Youll also need to vacuum to waste when there is a large amount of debris or leaves in the pool, usually at opening. Vacuuming to WASTE can only be accomplished if a multiport valve controls your pool filter system. This position bypasses the filter and sends all the unwanted debris through the waste line.

Should I backwash or vacuum first?

The vacuum end. It will allow air to be sucked in if its out of the water. Sand filters are forgiving; however, your method is causing you more work because after vacing in the Rinse mode, you will then need to Backwash, causing even more water loss.

What is the difference between backwash and waste on a pool filter?

Drain/Waste: Opting the drain or waste setting will remove pool water without forcing it through the filter. Backwash: This clears out any debris, dirt and other contaminants that may have accumulated on the filter. Closed: if you choose this setting, then the flow of water to the pool and filter will be stopped.

How often should I vacuum to waste?

In general, its a good idea to vacuum your pool once a week. You should also vacuum your swimming pool any time you notice large amounts of debris, dirt, or leaves on the floor of the pool (for example, your pool may need vacuuming after a heavy storm).

How much water do you lose when you backwash a pool?

about 6,300 gallons The backwashing of a typical Olympic-sized pool results in the loss of about 6,300 gallons of water per backwashing cycle, according to Recreation Management. As a result, dont add chemicals to your water until after youve backwashed — otherwise, youre just throwing money down the drain… literally.